First, examine the spark plug lead to see if OK to install a new boot and cap. If the plug wire is covered with heat shrink and it is worn through to the
metal braid, this will not hurt just clean it off and put some tape on it. If the braid is worn through but not worn into the plug, lead core, wrap it with
some kind of braid and tape tightly. Solder wick works good to wrap over the damaged spot on the braid it can be spot soldered on if you wish.
We can replace the braid and heat shrink but not the spark plug wire on the CHRCEXL &RCEXL Ignition. If the center core of the lead is cut or
almost worn to the center conductor, you will need a new spark plug lead. The spark plug lead itself cannot be replaced you are in the market for
a new ignition. You can put a couple of pieces of heat shrink tubing over the bad spot then put on new braid and heat shrink on complete plug wire.
Check your spark plug wire over good before you order a new cap then you can order new braid and heat shrink. If your spark plug lead is not
covered with heat shrink this would be a good time to do so. The spark plug lead is not replaceable on many ignition systems.
We can replace any part on the C&H heavy duty Ignition system. More
