3. Using the instructions for the Sychro-Spark ignition, static time the engine.Remove the spark plug leaving the boot attached and ground the plug body to the engine.
    Warning, if plug is not grounded you can burn up the sensor!
    Connect the ignition to the pulse switch and battery. Turn on the ignition then turn the engine over slowly and you should see or hear the spark fire before the engine         passes top dead center. The set the timing to 30 - 32 degrees BTDC.

4. If you do not get spark after installing the ignition system follow the trouble shooting on the installation instructions.

STARTING

1. With full choke, throttle cracked, and model restrained, turn on the ignition.
2. Using a heavy glove or chicken stick, crank normally until the engine pops. Then open the choke and crank the engine until it starts, usually two or three flips.
    You don't need to slap the prop.
3. To stop the engine turn of the ignition.

Although the G-26 is not a big engine it is big enough to cause a lot of harm so always practice safety!

Back